Facts About Magnetic Car Mount, WixGear Universal Stick On Mount (2 Pack) Dashboard Magnetic Phone Holder for Car, for Cell Phones and Mini Tablets with Fast Swift-snap Technology, Strong Phone Mount for Car
If you put the metal plate in the center.of your phone then a wireless charger won’t work. The best I have found is to mount the metal plate to the inside of the phone case so the case can be removed and the wireless charger will work.
I am not certain what your question refers to. The magnetic mount is intended to be stuck to your dashboard only. You need to apply one of the flat metal plates to your phone. If you have mistakenly stuck the whole mount to the phone, try using some Goo-Gone and carefully peel it off the phone.
The sticking pad is 2×1¼ inches,
The magnetic surface is 1¾ inches radius,
The unit is 1½ inches deep from the surface it’s sticking onto, to the magnetic surface.
I had no issue to removed, just be careful to slowly remove and the sticker will be free with no marks on dashboard.
Because they cheated you
Depends of the surface and moisture where it will be fixed. If it’s dry most of the time I would say it would be good for some time.
Yes and no…I use mine at a 45* quite often when I’m using the Waze app because of where mine is mounted, the stering wheel slightly blocks my view. By turning it to a 45*, I’m allowed to view the entire screen. There’s nothing that locks it to that position other than the magnetics but it holds it just fine.
It is not a suction cup it is a super sticky strip that adheres to most surfaces. The flat side that sticks does have a little give to it, so it could be placed on a slightly curved surface.
Yes it can. It screws off, but then it’s not flat on the back side if that’s what you’re wanting. It’s got the threaded "neck" that is a molded part of the magnet housing that sticks out about a 1/2" once you screw it off the ball. Hope this helps.
The mount is rotatable, you may loosen the plastic nut then position it to your liking then tighten the plaatic nut back tight. Once its set it will remain firm at its orientation. You can then attach your phone with the magnet or a magentic case. Once the phone and the mount are in contact it will stick and stay. Even… The mount is rotatable, you may loosen the plastic nut then position it to your liking then tighten the plaatic nut back tight. Once its set it will remain firm at its orientation. You can then attach your phone with the magnet or a magentic case. Once the phone and the mount are in contact it will stick and stay. Even though you tightened the mount, while the phone is attached you can easily move the phone with light pressure to readjust your viewing prefrence. The phone does not need to be centered on the mount to use it depending where you apply the magnetic. In most cases the magnetic or magnetic cases usually have the magnetic directly on the center of the phone
I have had no problems with the metal plate. Ideally, us the smaller round plate to minimize any possible interference.
Wet to clean the area.
It has had no effect on mine in the 2 years I’ve used it. The magnet is not the piece ttached to your phone.
Sure. The magnet has an adhesive tape on the back, so it will stick to just about anything. But why would you want it to obstruct your view when you can stick it to your dash?
Definitely! Although, the metal plate is not the magnet. Moreover, in my experience the size of the metal plate is more important. The short answer is yes, it will work.
Info About Magnetic Car Mount, WixGear Universal Stick On Mount (2 Pack) Dashboard Magnetic Phone Holder for Car, for Cell Phones and Mini Tablets with Fast Swift-snap Technology, Strong Phone Mount for Car (Reviews From Amazon)
The media could not be loaded. OK- maybe that was a smidge overkill there but this product has reduced stress, kept me more organized, and increased safety while driving! Win, win, win!
I applied it to the plastic smooth shiney front of the car radio panel in my Subaru Outback. It stuck there all summer (it was a hot summer in NY, definitely no Arizona level heat but it isn’t the heat anyway, right? It’s the humidity. But I digress…) and didn’t show any sign of letting go as other reviewers have mentioned happened in heat.
I wish I had applied it 180 degress from how I did due to the amount of rotation I get- it is just a smidge more angled up than I would like so test that out first. I use a magnetic charging cable by wsken and the combination of these means I can secure the phone and connect the charge cable one handed.
The phone has never fallen off this. My previous solutions all failed at one point or another (I’ve owned this for about 6 months).
Additionally, I own the Belkin Clip Fit running armband (the case part stays on all the time and then it clips into the armband). I was thrilled to find that this still works with the round ultra thin magnet adhered to the back. You can use the unused magnet to make something else magnetic. They are super strong.
See my review of the rectangle style for a visual comparison of the round and rectangle side by side.
This is the best idea for cell phones since sliced bread. I just place the phone on the dashboard. Violá! I use my phone for navigating with Google Maps or Waze. So I put the magnet-holder at the perfect spot on the dashboard where it’s high enough for just a quick glance but not too high to be in the windshield view. My only installation challenge is that there are no really flat surfaces in a convenient spot. So I used an additional small strip of the installation tape at top and bottom of the full strip of installation tape to allow as much contact as possible to compensate for the curve of the dash. It’s holding to the dash and, of course, the magnet holds to the phone perfectly. I’ve just had it for a week so I really can’t attest to long term use. However, so far, it’s working as expected.
Because my phone has a leather wallet case for protection, I was concerned there might not be enough magnet strength to hold the phone in place. As you can see from the photo, I was able to place the magnet plate in one of the wallet pockets. I then folded the pocket part back and secured it with a small binder clip that can be flipped down when not needed. Even though the weight is slightly above the recommended weight of 7 oz. it holds onto the magnet exceptionally well. I also do not have a very large space for mounting, so was pleased the mounting plate was not too wide. I tried a vent mount (different brand) and a power outlet mount and they were too putzy to attach the phone to the holder and didn’t hold position firmly. These are great for anyone who needs a quick secure mount (ie: in and out for delivery). I do geocaching and it’s great for navigating to the coordinates and remounting after getting out and in the car. It is easy to adjust your phone horizontally or vertically and the price is quite reasonable. I’ve only had this product a few days, but so far I am HIGHLY SATISFIED!!
These are not the first ones I have bought. I have had one for a couple of years and like the permanent mount, the mag holds great no matter how rough the road is the phone stays put. This purchase was one for my wife’s car and since putting it in she loves it as well. My only comment is I had to install upside down (meaning the little plastic catch for the cord is facing down) in order for me to get the correct angle so the phone is facing me directly both. The fords (explorer and escape) have a angled area to stick the base on and in order to over compensate that angle you get more movement for the perfect tilt, by putting them upside down…
These are great, if you have awkward vents, or they would not be in a great spot, especially for the drivers – these stick on ones are the perfect alternative. Plus you don’t have to worry about the magnet coming with your phone when you remove it to leave your vehicle, which tends to happen with the vent ones. Strong magnets, which is great. The vent ones are handy if you plan on renting a car as it is easy to pack with your chargers and then you have the GPS mount with you in the rental car. Not as optimal but it is better than getting lost and paying extra for the GPS package the rental company would charge.
I have an iPhone X and I have been in search of the best case & mount combo. I recently purchased the Totalee Ultra Thin Case. (Navy Blue), Spegen Style Ring and the WizGear universal magnetic mount. I could not be happier.
Totalee Ultra Thin Case is amazingly thin, has a great texture to it, feels as solid as a naked phone and is brand free, except being transparent enough to barely see the Apple logo. All of the cutouts line up perfect and it is so thin that all cables plug in easily.
Spegen Style Ring is a very thin, metal ring that opens 180 degrees and swivels 360. This is so much thinner and more “grown up” looking that a pop socket. It can act as a phone stand for watching videos, a secure holder for selfies and a metal base for magnetic mounts. The build quality feels fantastic. It’s entirely metal, solid construction and smooth operation are first class.
WizGear universal magnetic mount is a great value. The construction is almost entirely plastic; however, the mount looks and feels very solid. I used the ball joint from an old vent mount to put one WizGear in my travel kit for use in rental cars and the other one is stuck to my dash. The magnet is powerful enough to hold my phone securely.
I highly recommend each of these three products to create a super slim, great looking and secure phone holding set.
I was skeptical about the metal plate working when placed inside a phone case.
I have a fairly thin phone case and didn’t want anything stuck to the outside of it.
The magnetic base is good quality and has enough flexibility to contour to the autos dash.
The locking nut works well.
Even through the phone case the magnet holds securely even when in bumpy terrain.
Not to mention the price was right.
Great product and a great value
I’ve used this almost daily for the last 3 years. I can confidently recommend this to anyone. I don’t need to write a long review because there are so many others that are going to say the same thing but I noticed the biggest reason for the issues people are having is the adhesive quality.
I’ve only had to remount this one time and after I knew exactly why. You best place to mount this is on a solid/stiff surface. Most dashboards have this somewhere but on my 2009 Nissan Maxima there is a firm area around the display that I initially mounted this. It began to peel and fall off after about 5 months. I then replaced this in a different spot and it’s been on this same spot, firmly with no issues, for almost 2.5 years now and still showing no signs of losing it’s adhesive grip. The difference between the first and second location I had this is that the first spot was this thick and firm area around the console display but if you pressed it you could push it in a little. Think like a thick rubber floor at the gym. The surface was also slightly textured. Then I moved it to the second spot which was a solid and stiff piece of plastic that was surrounding the LCD display and it has been perfect here ever since.
My biggest tip for this stay in place is to make sure you’re mounting it on a nontexturerd solid and stiff surface. Do not mount this on something that is soft or textured.
I am really impressed with this. I am an over the road truck driver and trucks are very rough riding. However, even with the small version of this magnetic mount, my phone (Samsung galaxy s4) always stays in place on the magnet. I use this for my 7 inch tablet too but it will sometimes come off the magnet as it is much larger and heavier than the phone is. However there are several larger versions of this product that would definitely hold the tablet just as securely. I really don’t have any complaints. Even the sticky stuff that mounts this to my freightliners textured dashboard is excellent.
This is by far the best car mount style. I tried the air vent. My phone blocked the cold air from my AC in the hot Texas sun! And the clip would randomly fall out of the vent, usually when I needed the navigation the most.
Then I tried one that slips into the CD player slot. Very bulky. And since it gripped my phone with side grips, the grips blocked my side buttons. And randomly the grips would loosen and drop my phone, again at very inconvenient times.
This product has an adhesive that is very strong, but not permanent. So you can rest assured that it will hold your phone in place, but when you want to sell the car, the adhesive can be removed. The magnetic holder is much less bulky. Your phone will easily attach and detach with the strong magnet.
This product is well made, and less expensive than the other car mounts I described, and an overall better product.
|Magnetic Car Mount, WixGear Universal Stick On Mount (2 Pack) Dashboard Magnetic Phone Holder for Car, for Cell Phones and Mini Tablets with Fast Swift-snap Technology, Strong Phone Mount for Car||4.4||View On Amazon|
Leave a Reply